Material for pergolas, fences and metal gates

A metal pergola is usually built with a tube structure, anchored to the ground or the wall, and a roof on top. This is what's usually needed:

• Structure: square tubes and rectangular in 6 m bars, in black or galvanised. For outdoor use, see our guide on black or galvanised steel.
• Ground anchoring: base plates for the posts and chemical anchors or concrete anchors.
• Roof: roof sandwich panel 30 mm, cut to size from 1 to 13 m, with screws and joint cover included, or trapezoidal sheets.
• Fixing and finishing: self-drilling screws to fix sheet without pre-drilling and tube caps to close off the ends.
• Finish: primers and sprays to protect and paint.

Tube sizes depend on the size of the pergola and the load it will carry. For large structures, consult an engineer; we'll help you prepare the material.

Depending on the type of enclosure, we have three complete systems in stock:

• Single-twist mesh: mesh in 25 m rolls, in heights of 1, 1.5 and 2 m, with Ø 50 mm posts, struts, tensioners, clamps and wire. In galvanised and green.
• Hércules panel: green 2.5 m panels with 5 mm wire, in heights of 1, 1.5 and 2 m, with 60 × 40 mm posts and their fixing and anchoring accessories.
• Welded mesh: galvanised 3000 × 2000 mm panels with 4 mm wire.

We also have diamond mesh and galvanised mobile fencing for building sites.

• Frame: tubes, angles and flat bars.
• Infill: galvanised Pegaso sheet for gates, 200 slat, perforated sheet or elements of wrought iron.
• Swing gates: hinges and pintles and pivot points.
• Sliding gates: tracks, wheels and guides. We explain it in the guide on sliding gate hardware.
• Locking: barrel bolts, locks, lever handles and padlocks.